58
Chapter 5 - Using SETUP
Serial Port 1
This setting controls which of the COM ports are to be used for
the RS-232C connector. By default, the computer uses the
following values. Name: COM1. I/O address: 03F8h. IRQ: 4.
Parallel Port
This setting assigns the I/O address and IRQ for LPT1 and
LPT2 as required for the parallel port. By default, the computer
uses the following settings. Name: LPT1. I/O address: 0378h.
IRQ: 7. Use these values when your printer requires the
parallel port.
Parallel Port Mode
Specifies the direction of the parallel port: either unidirectional
or bidirectional. (Default: Bidirectional).
Note: If you use the port as an Enhanced Parallel Port (EPP), set Parallel Port Mode
to “Bidirectional.”
Internal Mouse
Set to “Disabled” if you use an external serial mouse. (Default:
Enabled).
LCD Brightness
Adjusts the LCD brightness. (Default: Normal). Set to “Half” to
extend the battery life.
Password
Lets you set a password for your system. See “System Security”
for details.
Comments to this Manuals