ZEOS PANTERA User's Guide Page 61

  • Download
  • Add to my manuals
  • Print
  • Page
    / 77
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 60
61
Software
1. Access the system SETUP utility by pressing F2 during
system boot.
2. Verify the following SCSI parameters in system SETUP,
Main Menu, SCSI BIOS Enable sub-menu:
SCSI BIOS [Enabled]
SCSI Controller Address [340H]
Synchronous [Enabled]
Enhanced [Enabled]
Parity [Enabled]
Disconnect [Disabled]
3. The on-board SCSI controller always uses IRQ11, non-
DMA. If other attached devices are using IRQ11, change
their settings to a different IRQ setting. The SCSI I/O port
default address is 340h (primary). The alternate address is
140h, but is not currently supported by the system BIOS.
4. Verify your system configuration to ensure other system
parameters have not changed. If any parameters have
changed, re-enter them and reboot your system.
For SCSI software driver installation and operation information,
refer to the appropriate Adaptec SCSI Device Driver
Installation Guide.
Chapter 8 - How to Install an Optional SCSI Controller Chip
Page view 60
1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 76 77

Comments to this Manuals

No comments